Chapter 7 Configuring Layer 2 Services Over Mpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Junose software for e series routing platforms
Table of Contents

Advertisement

Chapter 7
Configuring Layer 2 Services over MPLS
Before You Configure Layer 2 Services over MPLS
This chapter describes how to configure layer 2 services over MPLS on the router,
and contains the following sections:
Before You Configure Layer 2 Services over MPLS on page 529
Configuring Frame Relay Layer 2 Services on page 530
Configuring Interoperation with Legacy Frame Relay Layer 2 Services on page 530
Configuring Ethernet/VLAN Layer 2 Services on page 531
Configuring S-VLAN Tunnels for Layer 2 Services on page 532
Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces on page 533
Configuring Local ATM Cross-Connects with AAL5 Encapsulation on page 534
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation on page 536
Configuring HDLC Layer 2 Services on page 538
Configuring CE-Side Load Balancing for Martini Layer 2 Transport on page 540
Frame Relay over MPLS Configuration Example on page 544
MPLS L2VPN Tunnel over VLAN over LAG Configuration Example on page 547
MPLS L2VPN Tunnel over LAG Configuration Example on page 551
Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport
Examples on page 554
S-VLAN Subinterface with an Untagged C-VLAN ID Examples on page 557
Multiple ATM Virtual Circuits over a Single Pseudowire Example on page 560
Before you configure layer 2 services over Multiprotocol Label Switching (MPLS), we
recommend you be thoroughly familiar with MPLS and the type of layer 2 interfaces
that you want to configure.
Before you configure layer 2 services over MPLS, you must configure the layer 2
interfaces and MPLS.
Before You Configure Layer 2 Services over MPLS
529

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BGP - CONFIGURATION GUIDE V 11.1.X and is the answer not in the manual?

This manual is also suitable for:

Junose 11.1.x bgp and mplsBgpMpls

Table of Contents