Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
You can view the current value for this function with the
labeled as "Routing Mode."
Default
Format
Mode
14.2.1.1 no routing
This command disables routing for an interface.
You can view the current value for this function with the
labeled as "Routing Mode."
Format
Mode
14.2.2 ip routing
This command enables the IP Router Admin Mode for the master switch.
Format
Mode
14.2.2.1 no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
Mode
14.2.3 ip address
This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.
The value for
The value for
subnet mask of the interface. This changes the label IP address in
Format
Mode
Routing Commands
disabled
routing
Interface Config
no routing
Interface Config
ip routing
Global Config
no ip routing
Global Config
is the IP Address of the interface.
<ipaddr>
is a 4-digit dotted-decimal number which represents the
<subnetmask>
ip address <ipaddr> <subnetmask> [secondary]
Interface Config
v4.1, October 2008
command. The value is
show ip
command. The value is
show ip
show ip interface
.
14-7