Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
17.1.2 member
This command configures a switch. The
added/removed from the stack. The
supported switch types, indicating the type of the switch being preconfigured. The switch
index is a 32-bit integer. This command is executed on the Primary Management Unit.
Format
Mode
Note: Switch index can be obtained by executing the show supported switchtype
17.1.2.1 no member
This command removes a switch from the stack. The
switch to be removed from the stack. This command is executed on the Primary
Management Unit.
Format
Mode
17.1.3 switch priority
This command configures the ability of a switch to become the Primary Management
Unit. The
<unit>
allows the user to specify, priority of one backup switch over another. The range for
priority is 1 to 15, where 1 is the lowest priority and 15 is the highest. The switch with the
highest priority value will be chosen to become the Primary Management Unit if the active
Primary Management Unit fails. The switch priority defaults to the hardware management
preference value 1. Switches that do not have the hardware capability to become the
Primary Management Unit are not eligible for management.
Default
Format
Mode
17-2
<switchindex>
member <unit> <switchindex>
Stack Global Config
command in User EXEC mode.
no member <unit>
Stack Global Config
is the switch identifier. The
enable
switch <unit> priority <value>
Global Config
v4.1, October 2008
is the switch identifier of the switch to be
<unit>
is the index into the database of the
is the switch identifier of the
<unit>
is the preference parameter that
<value>
Stacking Commands