Lease; Network; Bootfile - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

7.1.7 lease

This command configures the duration of the lease for an IP address that is assigned from
a DHCP server to a DHCP client. The overall lease time should be between 1-86400
minutes. If infinite is specified, lease is set for 60 days. Days is an integer from 0 to 59.
Hours is an integer from 0 to 1439. Minutes is an integer from 0 to 86399.
Default
Format
Mode
7.1.7.1 no lease
This command restores the default value of the lease time for DHCP Server.
Format
Mode

7.1.8 network

Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
Default
Format
Mode
7.1.8.1 no network
This command removes the subnet number and mask.
Format
Mode

7.1.9 bootfile

The command specifies the name of the default boot image for a DHCP client. The
specifies the boot image file.
<filename>
Default
Format
DHCP Commands
1 (day)
lease {[<days> [hours] [minutes]] | [infinite]}
DHCP Pool Config
no lease
DHCP Pool Config
none
network <networknumber> [mask | prefixlength]
DHCP Pool Config
no network
DHCP Pool Config
none
bootfile <filename>
v4.1, October 2008
7-5