Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
18.2.8 no lldp med faststartrepeatcount
This command is used to the factory default value.
Format
Mode
18.2.9 show lldp med
This command displays a summary of the current LLDP MED configuration.
Format
Mode
Fast Start Repeat
Count
Device Class
18.2.10 show lldp med interface
This command displays a summary of the current LLDP MED configuration for a specific
interface or for all valid LLDP interfaces.
Format
Mode
Interface
Link
ConfigMED
LLDP and LLDP-MED Commands
no lldp med faststartrepeatcount
Global Config
show lldp med
Privileged EXEC
The number of LLDP PDUs that will be transmitted when the
protocl is enabled.
The local device's MED Classification. There are four
differenct kinds of devices, theree of them represent the
actual end points (classified as Class I Generic
[IP Communicatin Controller etc.], Class II Media
Conference Bridge etc.], Class III Communication
[IP Telephone etc.]. The fourth device is Network
Connectivity Device, which is typically a LAN
Switch/Router, IEEE 802.11 Wireless Access Point etc.
show lldp med interface [<unit/slot/port> | all]
Privileged EXEC
The interface in a unit/slot/port format.
Shows whether the link is up or down.
Shows if the LLPD-MED mode is enabled or disabled on this
interface.
v4.1, October 2008
18-11