Table of Contents
Advertisement
8800 Series Chassis Switch Hardware Installation Guide
Re-install the I/O module in the 8800 series switch following the instructions in
7.
XCM8000 Series Module
Remove a PoE Card XCM88P
To remove a PoE card:
Attach the ESD-preventive wrist strap to your bare wrist. If the metal end is not already
1.
connected, connect it to the ground receptacle at the top left corner of the chassis.
Remove the I/O module from the 8800 series chassis as described in
2.
Series Module
Loosen the spring-loaded captive retaining screws on the PoE card until they pop up.
3.
If the retaining screws are too tight to loosen by hand, use a 3/8-inch flat-blade
screwdriver.
At each end of the card, grasp the top and bottom edges and carefully lift the card to
4.
disengage the connectors.
Place the PoE card on an ESD-preventive work surface or into anti-static packaging.
5.
If you are replacing the PoE card, install the replacement card as described in
6.
Daughter Card XCM88P
Re-install the I/O module as described in
7.
Install an Option Card XCM888F in the Supervisory
Module
The Supervisory module has a slot for the XCM88F option card, which adds eight 1-gigabit SFP
data ports to the Supervisory module.
You need the following tools and equipment to install an option card:
ESD-preventive wrist strap
•
#2 Phillips screwdriver
•
#1 Phillips screwdriver
•
3/8-inch straight-tip screwdriver
•
CAUTION:
The XCM888F option card is not hot-pluggable. You must administratively
disable the module and remove it from the switch before you install the
option card
on page 62.
on page 66.
on page 75.
Install an XCM8000 Series Module
Chapter 8. Install or Remove Cards
Install an
Remove an XCM8000
Install a PoE
on page 62.
| 77
Advertisement
Table of Contents
