Show Mac-Addr-Table - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

19.1.7 show mac-addr-table

This command displays the forwarding database entries. If the command is entered with
no parameter, the entire table is displayed. This is the same as entering the optional
parameter. Alternatively, the administrator can enter a MAC Address to display the table
entry for the requested MAC address and all entries following the requested MAC
address. If the <unit/slot/port> is used, then the MAC addresses learned on that port is
displayed. If the VLAN option is used, then all the MAC addresses learned on that VLAN
are reported.
Format
Mode
Mac Address
Interface
Interface Index
Status
Static
Learned
Management
System Maintenance Commands
show mac-addr-table [<macaddr> |<unit/slot/port> |
VLAN all
<id>| ]
Privileged EXEC
A unicast MAC address for which the switch has forwarding
and or filtering information. The format is 6 or 8 two-digit
hexadecimal numbers that are separated by colons, for exam-
ple 01:23:45:67:89:AB. In an IVL system the MAC address
will be displayed as 8 bytes.
The port which this address was learned.
This object indicates the ifIndex of the interface table entry
associated with this port.
The status of this entry. The meanings of the values are:
The value of the corresponding instance was added by the
system or a user when a static MAC filter was defined. It can-
not be relearned.
The value of the corresponding instance was learned by
observing the source MAC addresses of incoming traffic, and
is currently in use.
The
value of the
corresponding
instance (system
MAC address) is also
the value of an
existing instance of
dot1dStaticAddress.
It is identified with port number one and is currently used
when enabling VLANs for routing.
v4.1, October 2008
all
19-15