Ip Igmpsnooping Maxresponse; Ip Igmpsnooping Mcrtexpiretime - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

15.1.4 ip igmpsnooping maxresponse

This command sets the IGMP Maximum Response time for the system, on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for
a particular group in that interface. This value must be less than the IGMP Query Interval
time value. The range is 1 to 3599 seconds.
Default
Format
Modes
15.1.4.1 no ip igmpsnooping maxresponse
This command sets the IGMP Maximum Response time (on the interface or VLAN) to the
default value.
Format
Modes

15.1.5 ip igmpsnooping mcrtexpiretime

This command sets the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN.
This is the amount of time in seconds that a switch waits for a query to be received on an
interface before the interface is removed from the list of interfaces with multicast routers
attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no
expiration.
Default
Format
Modes
15-4
10 seconds
ip igmpsnooping maxresponse <1-3599>
Global Config
Interface Config
VLAN Mode
no ip igmpsnooping maxresponse
Global Config
Interface Config
VLAN Mode
0
ip igmpsnooping mcrtexpiretime <vlanId> <0-3600>
Global Config
Interface Config
v4.1, October 2008
IGMP Snooping Commands