Ip Rip Send Version; Hostroutesaccept - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

14.6.11 ip rip send version

This command configures the interface to allow RIP control packets of the specified
version to be sent.
The value for <
(RIP version 1 compatibility mode) which sends RIP version 2 formatted packets via
broadcast,
rip2
control packets to be sent.
Default
Format
Mode
14.6.11.1 no ip rip send version
This command configures the interface to allow RIP control packets of the default version
to be sent.
Format
Mode

14.6.12 hostroutesaccept

This command enables the RIP hostroutesaccept mode.
Default
Format
Mode
14.6.12.1 no hostroutesaccept
This command disables the RIP hostroutesaccept mode.
Format
Mode
14-58
> is one of: to broadcast RIP version 1 formatted packets,
rip1
mode
for sending RIP version 2 using multicast, or
rip2
ip rip send version {rip1 | rip1c | rip2 | none}
Interface Config
no ip rip send version
Interface Config
enabled
hostroutesaccept
Router RIP Config
no hostroutesaccept
Router RIP Config
v4.1, October 2008
to not allow any RIP
none
Routing Commands
rip1c