Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
19.3.2.1 no logging wrap
This command disables wrapping of in-memory logging and configures logging to stop
when the log file capacity is full.
Format
Mode
19.3.3 logging console
This command enables logging to the console. You can specify the
value as either an integer from 0 to 7 or symbolically through one of the following
keywords:
emergency
informational
Default
Format
Mode
19.3.3.1 no logging console
This command disables logging to the console.
Format
Mode
19.3.4 logging host
This command enables logging to a host. You can configure up to eight hosts. The
is the IP address of the logging host. The
<ipaddr>
to 65535. You can specify the
symbolically through one of the following keywords:
(2),
(3),
error
Default
Format
Mode
19.3.5 logging host remove
This command disables logging to host. See
page 26
for a list of host indexes.
System Maintenance Commands
no logging buffered wrap
Privileged EXEC
(0),
(1),
alert
(6), or
(7).
debug
disabled; critical
logging console [severitylevel]
Global Config
no logging console
Global Config
<severitylevel>
(4),
(5),
warning
notice
port - 514; level - critical;
logging host <ipaddr> [<port>][<severitylevel>]
Global Config
v4.1, October 2008
(2),
(3),
critical
error
<port>
value as either an integer from 0 to 7 or
emergency
(6), or
informational
Section 19.3.11 "show logging hosts" on
<severitylevel>
(4),
warning
notice
value is a port number from 1
(0),
(1),
alert
critical
(7).
debug
(5),
19-23