NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual page 301

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Router Priority
Retransmit
Interval
Hello Interval
Dead Interval
LSA Ack Interval
Transit Delay
Interval
Authentication
Type
The information below will only be displayed if OSPF is enabled.
OSPF Interface
Type
State
Designated
Router
Backup
Designated
Router
Number of Link
Events
Metric Cost
Routing Commands
A number representing the OSPF Priority for the specified
interface.
A number representing the OSPF Retransmit Interval for the
specified interface.
A number representing the OSPF Hello Interval for the speci-
fied interface.
A number representing the OSPF Dead Interval for the speci-
fied interface.
A number representing the OSPF LSA Acknowledgement
Interval for the specified interface.
A number representing the OSPF Transit Delay for the speci-
fied interface.
The OSPF Authentication Type for the specified interface
are: none, simple, and encrypt.
Broadcast LANs, such as Ethernet and IEEE 802.5, take the
value . The OSPF Interface Type will be 'broadcast'.
broadcast
The OSPF Interface States are: down, loopback, waiting,
point-to-point, designated router, and backup designated
router.
The router ID representing the designated router.
The router ID representing the backup designated router.
The number of link events.
The cost of the OSPF interface.
v4.1, October 2008
14-47