Show Arp Switch - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

This section describes the system maintenance commands available in the 7300S Series
Stackable Switch CLI.
The System Maintenance Commands section includes the following subsections:
• Section 19.1 "System Information and Statistics Commands" on page 1
• Section 19.2 "System Utility Commands" on page 18
• Section 19.3 "Logging Commands" on page 22
• Section 19.4 "CLI Command Logging Command" on page 27
• Section 19.5 "Configuration Scripting Commands" on page 28
The commands in this section are in one of four functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Copy commands transfer or save configuration and informational files to and from the
switch.
• Clear commands clear some or all of the settings to factory defaults.
19.1 System Information and Statistics Commands
This section describes the commands you use to view information about system features,
components, and configurations.

19.1.1 show arp switch

This command displays connectivity between the switch and other devices. The Address
Resolution Protocol (ARP) cache identifies the MAC addresses of the IP stations
communicating with the switch.
Format
System Maintenance Commands
System Maintenance Commands
show arp switch
v4.1, October 2008
Chapter 19
19-1