Set Garp Timer Join - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

This section describes the Generic Attribute Registration Protocol (GARP), GARP VLAN
Registration Protocol (GVRP), and Garp Multicast Registration Protocol (GVMP)
commands available in the 7300S Series Stackable Switch CLI. GARP is a protocol that
allows client stations to register with the switch for membership in VLANS (by using
GVMP) or multicast groups (by using GMRP).
This section contains the following topics:
• Section • "Configuration commands configure features and options of the switch. For
every configuration command, there is a show command that displays the
configuration setting.GARP Commands" on page 1
• Section 8.2 "GVRP Commands" on page 4
• Section 8.3 "GMRP Commands" on page 6
The commands in this section are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.GARP Commands
This section describes the commands you use to configure GARP and view GARP status.
The commands in this section affect both GVMP and GMRP.

8.1 set garp timer join

This command sets the GVRP join time for one or all ports and per GARP. Join time is the
interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-
registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
Format
GARP, GVRP, and GMRP Commands
GARP, GVRP, and GMRP Commands
20
set garp timer join <10-100>
v4.1, October 2008
Chapter 8
8-1