No Lldp Receive; Lldp Timers; No Lldp Timers; Lldp Transmit-Tlv - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Format
Mode

18.1.4 no lldp receive

This command is used to return the reception of LLDPDUs to the default.
Format
Mode

18.1.5 lldp timers

This command is used to set the timing parameters for local data transmission on ports
enabled for LLDP. The <interval-seconds> determines the number of seconds to wait
between transmitting local data LLDPDUs. The range is 5-32768 seconds. The <hold-
value> is the multiplier on the transmit interval that sets the TTL in local data LLDPDUs.
The multiplier range is 2-10. The <reinit-seconds> is the delay before re-initialization, and
the range is 1-10 seconds.
Format
Mode

18.1.6 no lldp timers

This command is used to return any or all timing parameters for local data transmission on
ports enabled for LLDP to the default values.
Format
Mode

18.1.7 lldp transmit-tlv

This command is used to specify which optional type length values (TLVs) in the
802.1AB basic management set are transmitted in the LLDPDUs. Use sys-name to
transmit the system name TLV. Use sys-desc to transmit the system description TLV. Use
sys-cap to transmit the system capabilities TLV. Use port-desc to transmit the port
description TLV.
Format
Mode
18-2
lldp receive
Interface Config
no lldp receive
Interface Config
lldp timers [interval <interval-seconds>]
[hold<hold-value>] [reinit <reinit-seconds>]
Global Config
no lldp timers [interval] [hold] [reinit]
Global Config
lldp transmit-tlv [sys-desc] [sys-name]
[sys-cap] [port-desc]
Interface Config
v4.1, October 2008
LLDP and LLDP-MED Commands