Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Note: This command fails if any attributes within the policy definition exceed the
Format
Modes
Note: You can only attach a single policy to a particular interface at any time.
13.5.1.1 no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname>
command.
Policy-Map
Note: This command causes a service to remove its reference to the policy. This
Format
Modes
13.6 DiffServ Show Commands
Use the DiffServ show commands to display configuration and status information for
classes, policies, and services. You can display DiffServ information in summary or
detailed formats. The status information is only shown when the DiffServ administrative
mode is enabled.
13-22
capabilities of the interface. Once a policy is successfully attached to an
interface, any attempt to change the policy definition, that would result in a
violation of the interface capabilities, causes the policy change attempt to
fail.
service-policy in <policyname>
Global Config
Interface Config
parameter is the name of an existing DiffServ policy; it is defined by the
command effectively disables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command
for DiffServ.
no service-policy in <policyname>
Global Config
Interface Config
v4.1, October 2008
Quality of Service (QoS) Commands