NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual page 241

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
If the Policy Name is specified the following fields are displayed:
Policy Name
Type
The following information is repeated for each class associated with this policy (only
those policy attributes actually configured are displayed):
Assign Queue
Class Name
Committed Burst
Size (KB)
Committed Rate
(Kbps)
Conform Action
Conform COS
Conform DSCP
Value
Conform IP
Precedence
Value
Drop
Mark CoS
Quality of Service (QoS) Commands
The name of this policy.
The policy type (Only inbound policy definitions are sup-
ported for this platform.)
Directs traffic stream to the specified QoS queue. This
allows a traffic classifier to specify which one of the sup-
ported hardware queues are used for handling packets
belonging to the class.
The name of this class.
This field displays the committed burst size, used in simple
policing.
This field displays the committed rate, used in simple polic-
ing.
The current setting for the action taken on a packet consid-
ered to conform to the policing parameters. This is not dis-
played if policing is not in use for the class under this policy.
This field shows the CoS mark value if the conform action is
set-cos-transmit.
This field shows the DSCP mark value if the conform action
is set-dscp-transmit.
This field shows the IP Precedence mark value if the conform
action is set-prec-transmit.
Drop a packet upon arrival. This is useful for emulating
access control list operation using DiffServ, especially when
DiffServ and ACL cannot co-exist on the same interface.
Denotes the class of service value that is set in the 802.1p
header of inbound packets. This is not displayed if the mark
cos was not specified.
v4.1, October 2008
13-25