Ip Route - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.2.3.1 no ip address
This command deletes an IP address from an interface. The value for
Address of the interface. The value for
which represents the Subnet Mask of the interface.
Format
Mode

14.2.4 ip route

This command configures a static route. The
<subnetmask>
hop router.
The
<preference>
value (sometimes called "administrative distance") of an individual static route. Among
routes to the same destination, the route with the lowest preference value is the route
entered into the forwarding database. By specifying the preference of a static route, the
user controls whether a static route is more or less preferred than routes from dynamic
routing protocols. The preference also controls whether a static route is more or less
preferred than other static routes to the same destination.
The following must be present before the static routes are visible:
• Enable ip routing globally.
• Enable ip routing for the interface.
• The associated link must also be up.
Default
Format
Mode
14.2.4.1 no ip route
This command deletes all next hops to a destination static route. If you use the
<nextHopRtr>
preference value of the static route is reset to its default.
Format
Mode
14-8
no ip address <ipaddr> <subnetmask> [secondary]
Interface Config
is a valid subnet mask. The
is an integer value from 1 to 255. The user can specify the preference
preference - 1
ip route <ipaddr> <subnetmask> <nextHopRtr>
[<preference>]
Global Config
parameter, the next hop is deleted. If you use the
no ip route <ipaddr> <subnetmask> [{<nextHopRtr> |
<preference>}]
Global Config
v4.1, October 2008
is a 4-digit dotted-decimal number
<subnetmask>
is a valid ip address. The
<ipaddr>
is a valid IP address of the next
<nextHopRtr>
is the IP
<ipaddr>
value, the
<preference>
Routing Commands