Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
19.7 Dumping System Information
The show tech-support command dumps all major system information into a file that can
be sent to NETGEAR product support for debugging purposes. The command output is
not displayed on the console. Use the copy command to transfer the dumped file to the
host PC.
Format
Mode
19.8 Setting the Output Length of show running-config
By default, the output of the show running-config command pauses after every 18 lines
of output. If you do not want the output to pause or you want to change the number of lines
displayed, the following commands are provided to control output behavior.
19.8.1 terminal length
This command specifies how many lines of output to display on the console before
pausing. When the value of 0 is used, the output will not pause.
Format
Mode
19.8.2 terminal no length
This command resets the number of lines displayed by the show running-config
command before pausing to the default value of 18.
Format
Mode
19.9 Save
The Save command makes the current configuration changes permanent by writing the
configuration changes to system NVRAM.
Format
Mode
19-32
show tech-support
Global Config
<0-24>
terminal length
Global Config
terminal no length
Global Config
save
Privileged EXEC
v4.1, October 2008
System Maintenance Commands