Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
10.1.18 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.1.18.1 no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.1.19 snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
SNMP Commands
'snmp-server enable traps linkmode' command.
snmp trap link-status
Interface Config
'snmp-server enable traps linkmode' command).
no snmp trap link-status
Interface Config
Section 10.1.11 "snmp-server traps linkmode" on page 10-6
snmp trap link-status all
Global Config
v3.0, January 2008
10-9