Snmp Trap Link-Status; Snmp Trap Link-Status All - NETGEAR GSM7212 - ProSafe Switch Cli Reference Manual

Layer-2 switches, software version 6.0
Hide thumbs Also See for GSM7212 - ProSafe Switch:
Table of Contents

Advertisement

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

10.1.18 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
10.1.18.1 no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode

10.1.19 snmp trap link-status all

This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
Format
Mode
SNMP Commands
'snmp-server enable traps linkmode' command.
snmp trap link-status
Interface Config
'snmp-server enable traps linkmode' command).
no snmp trap link-status
Interface Config
Section 10.1.11 "snmp-server traps linkmode" on page 10-6
snmp trap link-status all
Global Config
v1.0, February 2007
10-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents