Show Ip Dhcp Conflict; Dhcp And Bootp Relay Commands - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
DHCP
DISCOVER
DHCP REQUEST
DHCP DECLINE
DHCP RELEASE
DHCP INFORM
Message Sent:
DHCP OFFER
DHCP ACK
DHCP NACK

7.3.8 show ip dhcp conflict

This command displays address conflicts logged by the DHCP Server. If no IP address is
specified, all the conflicting addresses are displayed.
Format
Modes
IP address
Detection
Method
Detection time

7.4 DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies
between clients and servers when they are not on the same physical subnet.
7-14
The number of DHCPDISCOVER messages the server has
received.
The number of DHCPREQUEST messages the server has
received.
The number of DHCPDECLINE messages the server has
received.
The number of DHCPRELEASE messages the server has
received.
The number of DHCPINFORM messages the server has
received.
The number of DHCPOFFER messages the server sent.
The number of DHCPACK messages the server sent.
The number of DHCPNACK messages the server sent.
show ip dhcp conflict [ip-address]
Privileged EXEC
User EXEC
The IP address of the host as recorded on the DHCP server.
The manner in which the IP address of the hosts were found
on the DHCP Server
The time when the conflict was found.
v1.0, March 2006
DHCP Commands