Installing And Configuring The Cisco 1120 Secure Access Control Server - Cisco 1120 Installation Manual

Installing and Configuring the Cisco 1120 Secure
Access Control Server 4.2
This chapter describes how to install your CSACS 1120 Series appliance and connect it to the network.
This chapter contains:
•
•
•
•
•
•
•
•
Before you begin the installation, read the Regulatory Compliance and Safety Information for the Cisco
1120 Secure Access Control Server 4.2 and the Site Preparation and Safety Guide that is shipped with
your appliance.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Rack-Mounting Configuration Guidelines
Each CSACS 1120 Series appliance has a set of rack handles (installed at the factory). You will use these
handles later when you install the appliance in a 4-post rack. You can front (flush) mount or mid-mount
the appliance in a 19-inch (48.3-cm) equipment rack that conforms to the 4-post rack specification (the
inside width of the rack should be 17.5 inches [44.45 cm]). Mount the appliance in the brackets. When
the appliance is installed in the rack, it requires one EIA 1.75-inch (4.4-cm) vertical mounting space or
1 rack unit (RU) for mounting.
OL-19455-01
Rack-Mounting Configuration Guidelines
Mounting the CSACS 1120 Series Appliance in a 4-Post Rack
Connecting Cables
Connecting to the AC Power Source
Powering Up the CSACS 1120 Series Appliance
Removing or Replacing the CSACS 1120 Series Appliance
Initial Configuration
Next Steps
C H A P T E R
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
3
3-1