Configuring The Failure Recovery Mode - Cisco SCE 8000 10GBE Software Configuration Manual

Chapter 8 Configuring the Connection

Configuring the Failure Recovery Mode

The failure-recovery operation-mode command defines the behavior of the system after boot resulting
from failure.
Options
The following options are available:
•
•
The default value is operational.
From the SCE(config)# prompt, type:
Command
failure-recovery operation-mode
operational|non-operational
Configure the Failure Recovery Mode: Examples
Example 1
This example sets the system to boot as non-operational after a failure.
SCE(config)#failure-recovery operation-mode non-operational
Example 2
This example sets the system to the default failure recovery mode.
SCE(config)# default failure-recovery operation-mode
OL-30621-02
operational—After failure, the system will return to operational mode.
non-operational—After failure, the system will remain not operational.
Configuring the Failure Recovery Mode
Purpose
Specifies the desired failure recovery mode.
Cisco SCE 8000 10GBE Software Configuration Guide
8-21