•
Pause. Changes will be implemented but saved only temporarily until
deliberately saved as a new configuration or until you power off the SLPA.
All changes will be lost when you power off the SLPA.
Specifying A Power-Up Configuration
You can specify any one of the nine configurations (1 to 8 or Factory) as the
power-up configuration:
1. Press the Menu key until the following message displays:
MENU MODE
CONFIG. CONTROL
2. Press the ↓ key until the following message displays:
Power-Up Config.
1*
3. Press the + or – key to cycle through the options (1 to 8 and Factory).
When the desired number displays, press the
following message displays:
Power-Up Config.
X *
NOTE: If the configuration number has not been saved previously, the
following error message displays:
CONFIG. DOES NOT
EXIST/Save First
If this error message displays, see "Saving A Configuration" on
page 73. Once you have saved a configuration, repeat the steps in
this procedure.
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the IEEE
1284 interface.
1. Load the configuration to be changed (for example, Config. 1).
. .
a. Press the
key until the following message displays:
.
MENU MODE
CONFIG. CONTROL
Specifying A Power-Up Configuration
↵
key to select it. The
75