Mounting Accessories; U-Arm And Accessories - Printronix SLPA8000 User Manual

Mounting Accessories

U-Arm And Accessories

3/8-16 Socket Head
Cap Screw (4)
3/8 in. Washer
Mounting Clamp (2)
Support Rod (2)
The SLPA is designed so that it can be mounted to a stand, or other fixturing
device, using button head socket screws and U-arm. The offset arms are
provided to adapt the SLPA for mounting to the U-arm.
NOTE: The optional mounting stand that can be purchased with the SLPA
1. Secure the support rod to the side plates of the SLPA using the two
2. Secure the U-arm to the stand, or other mounting device using the two
3. Insert the support rods of the offset arms into the recessed section of the
Socket Screw (4)
3/8 in. Washer
Figure 34. U-Arm and Offset Arms
utilizes the U-arm configuration.
washers and four socket screws provided. (If the U-arm was purchased
with your SLPA, this may already be done.)
mounting clamps, two 3/8 inch washers, and four 3/8-16 soc
provided.
screws
U-arm and hold into place.
U-Arm And Accessories
U-Arm
ket head cap
255