Ignore Mode - Printronix SLPA8000 User Manual

Chapter 3
IGP/PGL SETUP

Ignore Mode

This parameter instructs the IGP to ignore the character selected under the
Select Character menu.
•
Disable (the default). The IGP does not ignore any characters.
•
Enable. The IGP ignores the character specified in the Select Character
menu.
Select Char
Instructs the IGP which decimal character (0-255) to ignore from the host.
The range is 0 to 255, and the factory default is 0.
Do FF at TOF
Determines whether the printer, with media already set at the TOF (Top-of-
Form) position, will advance media to the next TOF position upon receipt of
an FF command.
•
Enable (the default). The printer will advance media from the present
TOF position to the next TOF position upon receipt of an FF command,
causing a blank form.
•
Disable. The printer will not advance media from the present TOF
position to the next TOF position upon receipt of an FF command.
IGP100 Compatibl.
This parameter forces the output to correspond with IGP-100 printer output in
cases where there are differences.
The options are Disable (the default) and Enable.
Expanded Font
Expanded font allows you to print characters in different sizes with specified
parameters and to select which font face to use.
•
Scalable (the default). Uses scalable fonts.
•
Block. Uses block fonts.
•
Alt Block 1. Uses alternative block fonts with a different character set.
Scalable Size
This option determines whether scalable characters are sized based on
normal scaling or based on the size of block characters. If the option Block is
set, then the scalable character are made to be the same size as block
characters in the old IGP-X00 printers.
The options are Normal (the default) and Block.
140