Printronix SLPA8000 User Manual page 126

Chapter 3
PRINTER CONTROL Menu
Compatibility
This parameter allows you to make SLPA series thermal printers compatible
with other printers.
When trying to preserve compatibility with respect to barcodes, you may not
always be able to make them equal in size. This is due to the various dot-per-
inch differences between printer types. When an exact match cannot be
made, the barcode is reduced in size so that the form bounds will not be
compromised and the barcode will be readable.
•
Default. Use for optimum performance.
•
Laser. Forces the output to correspond with the Printronix laser line of
printers.
•
P5000. Forces the output to correspond with the P5000 line of line matrix
printers.
•
T3000. Forces the output to correspond with the T3000 line of thermal
printers.
•
T1006. Forces the output to correspond with the T1006 line of thermal
printers.
The factory default is Default.
Set Sharing
This option allows character sets to be shared between the active LP+
protocol and the active emulation. If CT is installed and active, choosing a
character set in the CT activates that character set in the active emulation and
LP+ protocols. (These changes are not visible on the front panel.) If Set
Sharing is not selected, only the LP+ protocol will share the CT's character
set.
Del Char frm Fls
This option deletes downloaded character(s) from flash memory.
Ld Char from Fls
This option loads downloaded character(s) from flash memory.
Save Char to Fls
This option saves downloaded character(s) to flash memory.
Del Char frm RAM
This option deletes downloaded character(s) from RAM.
Ld Char at PwrUp
This option loads downloaded character(s) from flash memory at Power Up.
The options are Disable (the default) and Enable.
126