Printronix SLPA8000 User Manual page 204

Chapter 6
Troubleshooting Display Messages
Table 11. LCD Message Troubleshooting (continued)
Displayed Message
DOWNLOADING TO
VALIDATOR
E00 EXE @ ADDR0
See User Manual
E01A TYPE 0x40
See User Manual
E01B TYPE 0x60
See User Manual
204
Can User
Explanation
Correct?
Yes Normal message when
the printer is
downloading emulation
software with a
validator option
installed.
NOTE: Many software
builds contain updates
to the Validator option.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Solution
No action required.
NOTE: The validator software
update can be verified in the
F/W Revision menu option of
the VALIDATOR menu. Shown
as: Example X326
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.