Printronix SLPA8000 User Manual page 109

Error Recover
This option determines how the printer handles data that was printing when
an error occurred.
•
Disable (the default). The printer will not reprint the label that was printing
when the error condition occurred.
•
Enable. The printer reprints the label that was printing when the error
condition occurred.
Ribbon Width
When Same As Paper is selected, the printer automatically adjusts the ribbon
operating parameters to match the installed media width. In those cases
where the media width is less than the installed ribbon width, the Set In Menu
option should be selected. After selection, the ribbon width is set to the proper
value by pressing the ↓ key and choosing the actual ribbon width using the +
and – keys. The chosen width is then selected by pressing the
factory default is Same As Paper.
Display Ribbon
When enabled, the remaining length of unused ribbon will display on the LCD
(when the printer is online).
The options are Enable (the factory default) and Disable.
Ribbon Low
This item defines the Ribbon Low condition for the ribbon supply spindle.
When set to a specific value, a ribbon low message will display along with a
flashing ONLINE status indicator to indicate the length of ribbon remaining on
the ribbon supply spindle has reached its specified value. The indicator will
continue to flash until the ribbon supply is exhausted. When Disabled, no
ribbon low condition will be indicated. A Ribbon Low condition will not prevent
printing.
The options are Disable (the factory default) and Enable.
Rbn Takeup Full
This enables or disables a fault message to display for a Ribbon Takeup Full
condition.
The options are Enable (the factory default) and Disable.
Units
This item selects either millimeters or inches as the unit of measure.
The options are In Inches (the factory default) and In Millimeters.
MEDIA CONTROL Submenus
↵
key. The
109