Table of Contents
Advertisement
Chapter
3
QUICK SETUP Menu
Ver Image Shift
This menu item specifies the amount to shift an image up (–) or down (+) for
precise positioning on the label. The actual height of the image is not affected
by this parameter. The allowable range is –1.00 inches to the current Label
Length value setting, up to a maximum of 12.80 inches, in 0.01 inch
increments.
The default value is 0.00 inches.
Hor Image Shift
This menu item specifies the amount to shift an image left (–) or right (+) for
precise positioning on the label. The actual width of the image is not affected
by this parameter. The allowable range is
–1.00 to +1.00 inches in 0.01 inch increments.
The default value is 0.00 inches.
Orientation
Specifies the image orientation to be used when printing the label.
•
Portrait (the default). Portrait refers to vertical page orientation, where
the height of a page is greater than its width. The top edge of the image is
parallel to the leading edge of the media. The following example is viewed
from the front of the printer.
NOTE: Portrait orientation applies to PGL
FEED
•
Landscape. Landscape refers to horizontal orientation, where the width
of a page is greater than its height. The top edge of the image is parallel
to the left edge of the media. The following example is viewed from the
front of the printer.
88
regarded as Inverse Portrait using PPI1.
4 inches
media.
the
of
edge
leading
the
to
parallel
is
image
the
of
edge
top
The
Leading Edge
®
and VGL emulations. This is
6 inches
Advertisement
Table of Contents
Troubleshooting
