Chapter
2
SLPA System Configuration Parameters
RFID Reader
This enables the RFID Reader.
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press ↓ and
displays.
3. Press the Menu key until RFID CONTROL displays.
4. Press ↑ or ↓ until RFID Reader displays.
5. Press + or – until Enable displays.
6. Press
GPIO Features
Sets the required GPIO features (select User Defined table, select Main table,
enable GPIO Print&Apply).
1. Press the Menu key to take the SLPA offline and into Menu mode.
2. Press ↓ and
displays.
3. Press the Menu key until GPIO CONTROL displays.
4. Press ↑ or ↓ until GPIO Tables displays.
5. Press + or – until User Defined displays.
6. Press
7. Press ↑ or ↓ until GPIO Sel. Table displays.
8. Press + or – until Main displays.
9. Press
10. Press ↑ or ↓ until GPIO Print&Apply displays.
NOTE: Admin User must be set to Enable in the PRINTER CONTROL menu.
11. Press + or – until Enable displays.
12. Press
52
↵
at the same time until ENTER SWITCH UNLOCKED
↵
to select Enable.
↵
at the same time until ENTER SWITCH UNLOCKED
↵
to select User Defined.
↵
to select Main.
↵
to select Enable.