Printronix SLPA8000 User Manual page 110

Chapter 3
MEDIA CONTROL Menu
Set Label Length
This feature selects whether the Sensed Distance value derived from an Auto
or Manual Calibrate will be used to set the Label Length value in the MEDIA
CONTROL menu (and the QUICK SETUP menu).
•
Manual (the default). The Sensed Distance value derived from an Auto or
Manual Calibrate will not override or change the Label Length value.
•
Automatic: When an Auto or Manual Calibrate is performed, the Sensed
Distance value derived from either calibrate will override and change the
Label Length value. If no Auto or Manual Calibrate is performed, the
current Label Length value will be used.
NOTE: When Set Label Length = Automatic and Gap/Mark Sensor = Gap,
Peel-Off Mode
Prints and peels die-cut labels from the liner without assistance. The printer
waits for you to take away the label before printing the next one (on-demand
printing). When the optional internal rewinder is installed with liner attached, a
"Remove Label" message will display to remind you to remove the label
before the next one can be printed. The options are Fast (the default) and
Standard.
TOF Detect Fault
Allows selection of three different TOF (Top-of-Form) detection faults.
NOTE: The correct Label Length value, equal to the physical length of the
•
3 Labels (the default). The printer displays a Gap Not Detected fault and
stops printing when media has advanced a distance equal to three or
more times the Label Length value set in menu.
•
9 Labels
•
1 Label
110
Advanced Gap, or Advanced Notch, the printer will subtract the
Gap Length value (in the CALIBRATE CTRL menu) from the Sensed
Distance value obtained when the Auto or Manual Calibrate was
performed.
installed label, must be entered in the QUICK SETUP or MEDIA
CONTROL menu.