Installing The Slpa; Unpacking Your Slpa; Mounting The Slpa - Printronix SLPA8000 User Manual

Installing The SLPA

Unpacking Your SLPA

The SLPA has been securely packaged for protection during transportation.
Once received, follow the steps outlined below to ensure that the SLPA is not
damaged.
1. Remove the top layer of protective paper from the SLPA.
2. Lift the SLPA from the protective bottom layer of the box.
CAUTION
Do not lift or pull the SLPA by gripping the applicator pad, the
pneumatic tubing, the printhead assembly or ANY ROLLERS which are
located on the front of it.
3. Save the shipping container and protective layers of paper to ensure
4. Organize all items as they are unpacked from their containers. Carefully
5. Consult the enclosed packing slip for contact information if any item is

Mounting The SLPA

The mounting method for the SLPA allows for side, top, or bottom
applications.
NOTE: Specify the orientation of the SLPA when ordering. If the system is to
If the bottom base plate is used, the SLPA can easily be mounted to any flat
surface using the four 3/8 - 16 UNC holes provided. If the SLPA is mounted
using the 0.39 inch diameter holes provided on the side panels, special
fixturing may be needed to prevent potential damage to the connectors and
cabling in those areas.
To facilitate access to the control panel, the SLPA should be mounted at a
height between 2.0 feet (0.6 m) to 6.2 feet (1.9 m) above service level.
proper return shipping to Printronix, if necessary.
inspect each item for signs of damage. Make certain that all parts
(options) requested are received with the order.
missing or broken.
be used for bottom applications, custom work may be needed.
Unpacking Your SLPA
27