Printronix SLPA8000 User Manual page 125

Alarm
•
On (the default). An audible alarm sounds (3 beeps) when a fault occurs,
such as a paper jam.
•
Cont. Beep. A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
•
Off. No audible alarm sounds.
Power-up State
•
Online (the default). The printer powers up in the online state.
•
Offline. The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
PTX Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the "!" character.
Cancel Key
•
Disable (the default).
•
Enable. When enabled, the
all data in the print buffer, and deleted data will not be printed.
PRINTER CONTROL Submenus
key may be used in offline mode to clear
125