Printronix SLPA8000 User Manual page 107

Print Direction and Orientation are two independent options that can be
combined to produce the following results depending on the Active IGP
Emulation:
Print Direction
Orientation Option
Option
Head First
Head First
Head First
Head First
Print Direction
Orientation Option
Option
Foot First
Foot First
Foot First
Foot First
The factory default is Head First when IGP/PGL or IGP/VGL is enabled.
The factory default is Foot First when PPI/ZGL is enabled.
Tear-Strip Time
When Media Handling is set to Tear-Off Strip or when Media Handling is set
to Continuous and Continuous Mode is set to Tear Strip Full, Tear-Strip Time
specifies the number of seconds after the buffer is empty that the printer will
wait before it advances media to the tear bar position.
The range is .1 to 60.0 seconds, and the factory default is 1.0 second.
Lbl Missing Flt
Allows the Label Taken Sensor to first detect the presence of a label at the
tear bar for Peel and Tear Off Media Handling Mode only.
•
Enable (the default). The printer generates a fault condition if a missing
label is encountered.
•
Disable. The printer does not generate a fault condition if a missing label
is encountered.
MEDIA CONTROL Submenus
Table 2. Head First
Result in Active IGP Emulations
Portrait
Landscape
Inv. Portrait
Inv. Landscape
Table 3. Foot First
Portrait
Landscape
Inv. Portrait
Inv. Landscape
(IGP/PGL or IGP/VGL)
Portrait
Landscape
Inv. Portrait
Inv. Landscape
Result in Active IGP/PPI1
Emulation
Portrait
Inv. Landscape
Inv. Portrait
Landscape
107