List Of Messages - Printronix SLPA8000 User Manual

Chapter 6
Troubleshooting Display Messages
When printer logic detects a fault condition, three things happen:
•
The status indicator on top of the printer flashes on and off.
•
The audible alarm beeps if it has been enabled in the PRINTER
COUNTROL menu. Press PAUSE to silence the alarm.
•
The control panel LCD displays a fault message.

List Of Messages

Find the message in the Message List below and follow the suggested
procedure.
After correcting an error, press the PAUSE key to erase the message and put
the printer in the offline mode. If an error is not cleared, the printer will try to
print again but will display the error message until the error is cleared.
Displayed Message
06 HOST REQUEST
08 HOLD PRINT
TIMEOUT
15 COMM CHECK
22 INVALID ADDR
198
Table 11. LCD Message Troubleshooting
Can User
Explanation
Correct?
Yes Status message: in CT
emulation, the host
computer or printer
controller requires
attention.
Yes Status message: in CT
emulation, the printer
was offline more than
10 minutes and the
"Intervention Required"
parameter is set to
"Send to Host."
Yes/No Communication Check:
a message that
appears in the CT
emulation meaning the
line is not active on a
twinax interface.
Yes Invalid Address: poll
time-out on the twinax
interface indicating the
unit address is not
recognized by printer.
Solution
Not a printer problem.
Press PAUSE to put the printer
online.
1. Check your network for
proper operation.
2. Try a different cable from a
known good device.
3. If the problem persists,
contact your authorized
customer service
representative.
Have the system administrator
make sure the printer address
is correct.