Chapter
1
Overview
Overview
General Operation
This document contains information and instructions for the Printronix Smart
Label Printer Applicator (SLPA). The SLPA can print label patterns up to 4.1
inches (104 mm) wide and applies them by means of a pneumatic applicator
system, although optional methods of applying the label are available by
design. The User's Manual contains information on setup, operation, and
menu configurations, as well as adjustments and basic maintenance
procedures the operator can perform.
The SLPA is both a direct thermal and thermal transfer label printer. The
SLPA can be positioned for top, side, or bottom applications and mounted
using the mounting holes in either the base or sides.
NOTE: Specify the orientation of the SLPA when ordering. If the system is to
The SLPA is an integrated unit composed of the following modules:
•
Label printer engine
•
Label apply system
•
GPIO control system
•
Control panel (comprised of air controls, Liquid Crystal Display (LCD),
touch keypad/display, and air pressure gauges)
•
Label supply
•
Backing rewind system
These systems are packaged into a metal frame with an aluminum cover
enclosing the rest of the system. The metal frame is used for component
mounting, and all system controls are located on this frame.
22
Figure 1. SLPA Dimensions
be used for bottom applications, custom work may be needed.