Printronix SLPA8000 User Manual page 221

Table 11. LCD Message Troubleshooting (continued)
Displayed Message
Remove Label
RESETTING
PLEASE WAIT
RESTORING
BOOT CODE
RFID TAG
FAILED:Check Media
RFID MAX
RETRY:Check
System
RIBBON BROKEN
Reload Ribbon
Can User
Explanation
Correct?
•
Yes A label was
detected at the
front of the printer
by the Label Taken
Sensor. This is the
normal reminder
message when
Peel-Off or Tear-
Off Media Handling
has been selected.
•
A label was
removed, but the
"Remove Label"
message
remained.
•
The incorrect
Media Handling
mode was
selected.
Yes Printer finished loading
the program into flash
memory and is
automatically resetting
itself.
Yes Normal download
initialization message.
Yes Failed tag. Error
displays in STOP
mode, causing printer
to halt.
Yes Failed tag. Error
displays in
OVERSTRIKE mode.
Each failed label prints
with the OVERSTRIKE
pattern; the form retries
until the label retry
count is exhausted.
Yes Ribbon is broken
between the ribbon
take up spindle and the
printhead.
List Of Messages
Solution
1. Remove the label from the
front of the printer to allow
the next label to print.
2. Verify that a front door
assembly is installed on
the printer and that it is
properly closed. Ensure
that no debris is
obstructing the door mirror
or the Label Taken Sensor.
3. In the QUICK SETUP or
MEDIA CONTROL menu,
change Media Handling to
the correct selection.
No action required.
No action required.
Initiate reprint of the label from
the host. When the error is
cleared, the label with the
failed tag moves forward to the
next TOF position.
Clear the error. When the error
is cleared, the label with the
failed tag moves forward such
that the next label is in position.
Reattach ribbon.
221