Printronix SLPA8000 User Manual page 203

Table 11. LCD Message Troubleshooting (continued)
Displayed Message
CUTTER FAULT
Jam or Cut Fail
DEACTIVATING
HOST SERIAL
DIAGNOSTICS
PASSED
DIRECT THERMAL
Remove Ribbon
DO NOT POWER
OFF
Can User
Explanation
Correct?
Yes 1. Cutter assembly is
not in the closed
position.
2. Cutter option was
not able to
complete a full cut
cycle due to a jam.
3. Cutter PCBA
detected current
overload and
opened circuit
breaker on cutter
PCBA.
Yes Normal message that
displays when you set
Battery Monitor =
Enable in the
BATTERY CONTROL
menu.
Yes The printer passed its
memory and hardware
initialization tests.
Yes This is the normal
reminder message
when you change the
Print Mode setting from
Transfer to Direct in the
QUICK SETUP or
MEDIA CONTROL
menu.
No This is a standard
warning message that
displays while the
printer is downloading
software.
List Of Messages
Solution
1. Place the cutter assembly
in the closed (up) position.
2. Clear obstruction from the
cutter assembly.
3. Insure media thickness is
within specification.
Wait a few minutes for the
cutter circuit breaker to
automatically reset.
Press PAUSE to clear the
fault message and resume
printing.
No action required.
No action required.
1. Remove ribbon from the
ribbon supply and ribbon
take-up spindles in the
printer.
2. If ribbon is required for
printing, change the Print
Mode back to Transfer.
Do not power off the printer
until downloading is complete.
203