Printronix SLPA8000 User Manual page 76

Chapter 3
Setting SLPA Configuration Parameters
b. Press the ↓ key until the following message displays:
c. Press the + or – key to cycle through the options: Factory 1 to 8.
d. When the desired number displays, press the
2. Move through the menu and change all the desired values. (In this
example, press the Menu key until PARALLEL PORT displays. Press the
↓ key until Port Type/IEEE 1284 displays. Press the – key until Centronics
displays.)
3. Press the
4. Before saving the modified configuration, you must delete the original
configuration if the Protect Configs. option is enabled.
a. Press the ↑ or ↓ key until the following message displays:
b. Press the + or – key to cycle through the options (1 to 8). When the
5. Save the new configuration as described in the "Saving A Configuration"
on page 73. Make sure you select the same number (e.g., Config. 1)
when saving the modified configuration. The new configuration writes
over the existing one.
6. Print a copy of this newest configuration and store it in a safe place. Refer
to "Printing A Configuration" on page 77.
76
Load Config.
Factory
following message displays:
Loading Saved
Configuration
Then, the following message displays when it is loaded:
Load Config.
X *
↵
key to select each new value. An asterisk (*) displays.
Delete Config.
1*
desired number displays, press the
message displays:
Deleting
Configuration
Then, the following displays when it is deleted:
Delete Config.
X *
↵
key to select it. The
↵
key to select it. The following