Ethernet Speed
This menu appears only if a 10/100Base-T NIC (network interface card) is
installed.
The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks:
•
Auto Select (the default). Tells the 10/100Base-T NIC to perform an auto
detection scheme and configure itself to be 10 Half Duplex, 10 Full
Duplex, 100 Half Duplex, or 100 Full Duplex.
•
10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
•
10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
•
100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
•
100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
Job Control
•
Standard (the default). The NIC waits for the entire job to be received
before it indicates the job is done.
•
Enhanced. The NIC waits for the entire job to be printed before it
indicates the job is done.
•
Off. There is no synchronization between the NIC and the printer.
NOTE: For detailed information about using the NIC, refer to the Network
Interface Card User's Manual .
ETHERNET PARAMS Submenus
165