Printronix SLPA8000 User Manual page 237

Symptom
Bar code print jobs print as
control codes for IGP or Code
V bar code jobs.
Table 12. General Symptom List
1. Make sure the correct microcode to support IGP or Code V
emulation is loaded in the printer.
2. Verify the printer configuration has the correct active
graphics emulation selected as IGP or Code V in the
PRINTER CONTROL menu.
3. Make sure the SFCC character is set to what is being used
by the job. You can put the printer into hex-dump mode if it
is a non-IPDS printer to find what the SFCC character is.
4. If the printer also has IPDS microcode installed, ensure
the customer is not using an IPDS device profile to send
the IGP or Code V print job to the printer. If the printer is
defined as an IPDS device on the host, the customer will
then need to create another device profile that is NOT
IPDS. Refer the customer to the Coax/Twinax
Programmer's Reference Manual or the Network Interface
Card User's Manual for instruction on correctly creating a
different device profile that can utilize IGP or Code V
datastreams.
General Symptom List
Solution
237