Printronix SLPA8000 User Manual page 223

Table 11. LCD Message Troubleshooting (continued)
Displayed Message
SOFTWARE
ERROR*
Recycle Power
Speed Exceeds
Validator Limit
TESTING
HARDWARE
PLEASE WAIT
Unscannable Code
Check media
Validator not
communicating
Can User
Explanation
Correct?
Yes/No 1. Application
software tried to
perform an illegal
printer function.
2. There are
damaged logic
circuits on the
controller PCBA.
Yes The Print Speed or
Slew Speed value is
above 6 IPS as the
power-up default with
the validator option
installed, or the user
attempted to increase
Print Speed or Slew
Speed above 6 IPS.
Yes Normal power-up
message. Printer is
running its initialization
routine.
Yes Data validation error:
missing barcode.
Yes The Validator Funct. =
Enable in the
VALIDATOR menu, but
when the printer was
first powered up it
could not communicate
with the validator.
List Of Messages
Solution
1. Recycle the printer power.
If possible, print a job that
has previously worked.
2. If the problem persists,
contact your authorized
service representative.
Change the Print Speed or
Slew Speed value in the
MEDIA CONTROL menu to 6
IPS or less when using the
validator option, and save the
new value as the power-up
default.
1. No action required.
2. If the printer does not
complete initialization and
continues displaying this
message when the CT
emulation is installed, the
expansion CT board may
not be connected to the
controller PCBA.
Check the paper and ribbon for
cleanliness, wrinkles, etc., or
an obstructed validator beam.
If there is no validator beam at
all, or if the LED is not flashing
as barcodes pass through the
validator beam, recycle
validator power. If the problem
persists, contact your service
representative.
Check that the validator signal
cable is securely connected to
the validator unit.
223