Printronix SLPA8000 User Manual page 276

B
BAD VFU CHANNEL fault message, 200
BAR CODE IMPROPER Data Format fault
message, 200
BAR CODE QUIET Zone too small fault message,
200
Bar codes, 18
Barcode Demo, 197
Batch Counter option, 131
BATT HIGH VOLT fault message, 200
BATT LOW VOLT fault message, 201
BATTERY CONTROL
submenus, 177
BATTERY CONTROL menu, 176
Battery Monitor option, 177
Baud Rate option, 153
Beacon package options, 253
Beacon package, fault/warning, 253
Beacon, mounting, 254
Bold Chars. option, 130
Boundary Check option, 143
BUFFER OVERFLOW fault message, 201
BUFFER OVERRUN fault message, 201
Buffer Size in K option (Parallel Port), 149
Buffer Size in K option (Serial), 155
Busy on Strobe option, 151
Byte mode, 182
C
C/T PORT
menu, 160
submenus, 160
Cable length
IEEE 1284 parallel, 184
RS-232 serial, 185
Cal In Peel Mode option, 116
CALIBRATE CTRL
menu, 112
submenus, 113
Calibrating media sensors, 61
CALIBRATION Warning fault message, 202
Calibration warning fault message, 202
Cancel Key option, 125
276
CANNOT CALIBRATE Disable Peel-Off fault
message, 202
Cautions, 25
Changing SLPA settings, 72
Channel option, 173
Character Group option (PGL), 135
Checkerboard, printer test, 196
Checksum Failure fault message, 202
Cleaning, 187
applicator pad, 190
media sensor, 189
platen roller, 189
printhead, 189
schedule, 192
vacuum generator, 191
Clear Error Log option, 146
Clear To Send (CTS) signal, RS-232 serial
interface, 185
CLEARING PROGRAM FROM FLASH fault
message, 202
Clip Page option, 108
Communication
IEEE 1284 parallel (bidirectional), 181
Communications connection, 29
Communications interface specifications, 251
Compatibility mode, IEEE 1284 interface, 182
Compatibility option, 126
CONFIG. CONTROL
menu, 93
submenus, 94
Configuration menu
moving within, 71
Configurations
loading saved, 77
modifying saved, 75
printing, 77
saving, 73
specifying power-up, 75
Connections
air, 29
communications, 29
power, 29
specifications, 251