Main Menu - Printronix SLPA8000 User Manual

Chapter 3

Main Menu

Main Menu
QUICK
SETUP
(page 85)
Print Intensity
Print Speed
Print Mode
Media Handling
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
1
Gap/Mark Sensor
Auto Calibrate
Active IGP Emul
Save Config.
Power-Up Config.
2
SMT: Status
3
PAA: Status
Press Menu to select the next main menu.
Press ↓ or ↑ to move within each main menu.
Press + or – to cycle through each possible option or value.
NOTES:
Italicized items appear only if Admin User is set to Enable (in the
PRINTER CONTROL menu).
1
Gap/Mark Sensor and Paper Out Sensor work in conjunction.
If you change the Gap/Mark Sensor or Paper Out Sensor, you
must recalibrate the media.
2
This menu appears only if RFID is installed.
3
This menu appears only if RFID is not installed.
78
RFID
2
CONTROL
Refer to the RFID Load Config.
Save Config.
Labeling
Print Config.
Reference Manual.
Delete Config.
Power-Up Config.
Protect Configs.
Name Config 1
Name Config 2
Name Config 3
Name Config 4
Name Config 5
Name Config 6
Name Config 7
Name Config 8
Reset Cfg Names
CONFIG. MEDIA
CONTROL CONTROL
(page 93) (page 96)
Print Intensity
Print Speed
Print Mode
Media Handling
Paper Feed Shift
Label Length
Label Width
Ver Image Shift
Hor Image Shift
Orientation
Auto Map Select
Auto Label Width
Num Auto Labels
Slew Speed
Print Direction
Tear-Strip Time
Pre-Peel Mode
Pre-Peel Adjust
Lbl Missing Flt
Clip Page
Error Recover
Ribbon Width
Display Ribbon
Ribbon Low
Rbn Takeup Full
Units
Set Label Length
Peel-Off Mode
Continuous Mode
TOF Detect Fault
Ticket Save Mode
TOF Adjust Mode
TOF Adjust