Printronix SLPA8000 User Manual page 43

Lower Media
Media Guard
Media Sensor
Figure 12. Threading Media Through the Printhead Assembly
12. Slide the media width guide close to the outside end of the media
damper.
13. Thread the leader under the media damper and then between the platen
(rubber drive roller) and the printhead.
14. Verify that the inside edge of the leader is against the fixed guide on the
bottom of the media damper.
15. Push the media width guide in until it is flush with the outer edge of the
media.
NOTE: Do not wrinkle the leader by pushing the media width guide too close
to the SLPA panel.
16. Check the horizontal position of the lower media sensor (located under
the media guard). See "Positioning The Media Sensors" on page 54.
Sensor
Handle
Media Damper
Threading The Label Roll
Leader
Fixed Guide
Media Width
Guide
43