Printronix SLPA8000 User Manual page 128

Chapter 3
PRINTER CONTROL Menu
Auto Locking
•
Disable (the default). The
•
Enable. The printer automatically locks the
last control panel key press.
Set Lock Key
Normally, to lock or unlock the printer menu, the ↓ and
the same time. The Set Lock Key parameter lets you choose different keys to
lock or unlock the printer menu. You may choose almost any group of keys as
the new lock and unlock keys. You cannot use the
combinations which are already used for another function. There is no limit to
how many keys can be selected.
To set the new lock key:
1. Go to the PRINTER CONTROL main menu and select "Set Lock Key."
2. Press
3. Press the combination of keys that you want to be the new lock key. Make
sure you press all keys selected at the same time.
4. If the selection is valid, the display will read, "Enter the new lock key
again." Press the same combination of keys a second time. If the
selection is invalid, the display will read, "Invalid key selection." Return to
step 2 and start over.
5. If the new lock key combination is entered again correctly, the display will
read, "Lock key has been changed." If it was entered incorrectly, the
display will read, "Validation failed." Start over at step 1.
6. After entering the new lock combination successfully, press the PAUSE
key to put the printer back online.
NOTE: The new lock combination will remain even if the printer is powered
Ptx Setup Parse
•
Enable (the default). Will parse and execute the PTX SETUP commands.
•
Ignore. Will parse the PTX SETUP commands but not act on them.
•
Disable. Will not parse the PTX SETUP commands so they will print out
as text.
128
↵
(ENTER) key must be locked manually.
↵
. The display reads, "Select a new lock key."
off and back on.
↵
key five minutes after the
↵
keys are pressed at
↵
key or any key