Specifying A Power-Up Configuration - Printronix SL4M User Manual

Chapter 4

Specifying a Power-Up Configuration

The active option is highlighted. The operator can use the Up and Down keys
to scroll through the different options. The keys will loop at the top and bottom
options. The
Online after performing the selected option.
NOTE: Only the Up, Down, and Enter keys work at the Menu Changes
•
Save Permanently (default option). This option will cause the printer to
save the configuration to the active configuration and make the active
configuration the Power-Up default configuration. If the active
configuration is the Factory Configuration, the printer will save the
configuration to an open configuration and make that open configuration
the Power-Up default configuration.
If there is no open configuration, the operator must decide which
configuration to overwrite. In this case the printer will display the Save
Configuration menu, otherwise, the printer will go Online.
•
Save Temporarily. Menu changes will be implemented, but will not be
saved once the printer is powered off.
•
Cancel Changes. This option will cause the printer to reload the Active
Configuration and then go Online.
•
Restore Factory. This option will cause the printer to reload the Factory
Configuration and then go Online.
NOTE: A printer fault during the Auto Save process will cause the automatic
Specifying a Power-Up Configuration
You can specify any one of the nine configurations (1-8 or Factory) as the
power-up configuration:
1. Press the
2. Press the Right key until the following displays:
3. Press the ↵ key to enter the PRINTER SETUP menu.
4. Press the Up key until the following option is selected:
PRINTER SETUP
5. Press the ↵ key to enter the Admin User submenu.
6. Press the Right key until the following displays:
Admin User
150
↵
(Enter) key selects the highlighted option. The printer will go
Detected prompt.
selection of Save Temporarily.
. .
key to enter the menu configuration.
.
PRINTER SETUP
Admin User
Enable