3Com 7757 Configuration Manual page 292

292 C 33: RIP C
HAPTER ONFIGURATION
Configuring Basic RIP
Functions
n
Configuring the network layer addresses of interfaces so that adjacent nodes
■
are reachable to each other at the network layer
Enabling RIP globally and on the interface of a specified network segment
Table 214 Enable RIP globally and on the interface of a specified network segment
Operation
Enter system view
Enable RIP globally and enter
RIP view
Enable RIP on the interface of
a specified network segment
RIP can be enabled on an interface only after it has been enabled globally.
■
RIP operates on the interface of a network segment only when it is enabled on
■
the interface. When RIP is disabled on an interface, it does not operate on the
interface, that is, it neither receives/sends routes on the interface nor forwards
its interface route. Therefore, after RIP is enabled globally, you must also specify
its operating network segments to enable it on the corresponding interfaces.
Setting the RIP operating status on an interface
Table 215 Setting the RIP operating status on an interface
Operation
Enter system view
Enter interface view
Enable the interface to
receive RIP update packets
Enable the interface to
send RIP update packets
Run RIP on the interface
Specifying the RIP version on an interface
Table 216 Specify the RIP version on an interface
Operation
Enter system view
Enter interface view
Command
system-view
rip
network network-address
Command
system-view
interface interface-type
interface-number
rip input
rip output
rip work
Command
system-view
interface interface-type
interface-number
Description
-
-
Required
By default, RIP is disabled on
any interface.
Description
-
-
Optional
By default, except for
loopback interface, all
interfaces are allowed to
send and receive RIP
packets.
Description
-
-