Configuration Procedure
Configuration Example
Table 30 Configuration procedures of the Modem attribute
Operation
Enter system view
Enter AUX user interface view user-interface aux 0
Enable Modem call-in/call-in
and call-out
Set the answer mode to auto
answer.
Configure the carrier
detection timeout time after
off-hook during call-in
connection setup
# Enable Modem call-in and call-out, set the answer mode to auto answer, and set
the timeout time to 45 seconds.
<SW7750> system-view
[SW7750] user-interface aux 0
[SW7750-ui-aux0] modem both
[SW7750-ui-aux0] modem auto-answer
[SW7750-ui-aux0] modem timer answer 45
Modem Attributes Configuration
Command
system-view
modem [ call-in | both ]
modem auto-answer
modem timer answer
seconds
69
Description
-
-
Required
Call-in and call-out are
allowed when the command
is executed without any
keyword.
Optional
By default, manual answer
mode is adopted.
Optional
30 seconds by default.